The first sealant clinical trials used cyanoacrylate-based materials. These were replaced by dimethacrylate-based products which were marketed. A major difference between marketed sealants is their method of polymerization. First-generation sealants were initiated by ultraviolet light, second-generation sealants are autopolymerized, and third-generation sealants use visible light. Over time, clinical retention was found to be greater for second generation as compared with first-generation sealants. Five to 7 years after initial application the pits and fissures of approximately one third of teeth treated with first-generation sealants were fully protected as compared with two thirds of the teeth treated with second-generation sealants. First-generation, ultraviolet light initiated, sealants are no longer marketed. Clinical reports indicate that retention is similar for second- and third-generation systems, but longer clinical evaluations are necessary. A recent innovation is the addition of fluoride to sealants. Fluoride release to the saliva from a fluoride sealant system is rapid, but clinical studies are needed to determine if the fluoride addition improves caries inhibition.

Keywords:
Caries prevention, Fluoride, Pit-and-fissure sealants
This content is only available via PDF.
© 1993 S. Karger AG, Basel
1993
Copyright / Drug Dosage / Disclaimer
Copyright: All rights reserved. No part of this publication may be translated into other languages, reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying, recording, microcopying, or by any information storage and retrieval system, without permission in writing from the publisher.
Drug Dosage: The authors and the publisher have exerted every effort to ensure that drug selection and dosage set forth in this text are in accord with current recommendations and practice at the time of publication. However, in view of ongoing research, changes in government regulations, and the constant flow of information relating to drug therapy and drug reactions, the reader is urged to check the package insert for each drug for any changes in indications and dosage and for added warnings and precautions. This is particularly important when the recommended agent is a new and/or infrequently employed drug.
Disclaimer: The statements, opinions and data contained in this publication are solely those of the individual authors and contributors and not of the publishers and the editor(s). The appearance of advertisements or/and product references in the publication is not a warranty, endorsement, or approval of the products or services advertised or of their effectiveness, quality or safety. The publisher and the editor(s) disclaim responsibility for any injury to persons or property resulting from any ideas, methods, instructions or products referred to in the content or advertisements.
You do not currently have access to this content.